The new -S/-s/-d flags allow for manually specifying the time of sunset,
ssunrise in the format of HH:MM, and the transitional animation duration
in seconds, respectively.
This is implemented by sidestepping the calc_sun call in manual mode.
The rest of wlsunset operates as usual.
calc_sun reported sun trajectory in seconds since the start of a UTC
day, as they would occur for the specified UTC day. The caller would
then add the UTC timestamp for the start of a UTC day to these numbers.
This lead to complications, as e.g. a sunrise in China would be a
negative value, as it occurred in the last UTC day.
Futhermore, the start of a UTC day was used to signal the need for new
sun calculations. This would lead to recalculations to possibly occur
after its results were needed, such as after sunrise when the target
longitude deviated significantly from the prime meridian.
To fix this, we apply longitude time correction to the start of day
calculation. This way recalculation will occur on the start of the
longitude local day, close midnight for the observer.
We also remove the longitude time correction from calc_sun, so that it
simply returning the number of seconds since the start of the local day
of the observer. The caller then adds the start of the longitude local
day to get the final numbers.
The sun trajectory calculation previously emitted garbage if midnight
sun or polar night phenomena was in effect. To fix this, the calculation
is overhauled to report if the computation failed, and if so, which
specific phenomena was the cause.
Timing recalulation uses this information to change out of the normal
state that uses the four sun position timings, into a static state where
wlsunset simply waits a day at a time for a normal sun trajectory
pattern to be restored. In this state, a fixedc high/low temperature is
set as appropriate for the phenomena.
A transition phase replicating the previous day's sunrise is used to
smooth out entry into a midnight sun, which would otherwise cause a
jarring instant-daylight setting.
Low-to-high animation runs from sunrise to sunrise+duration. However,
high-to-low animation ran from sunset to sunset+duration.
Run high-to-low animation at sunset-duration to sunset.
The compiler is confused by the circular switch, and thinks that temp
might become uniniitalized. This is clearly false, as it is set at all
switch breaks.
Silence the warning by explicitly initializing it to zero.
Add a SPEEDRUN define which, if set, will run wlsunset at 200x
super-realtime to aid testing.
Sleep timing calculations were approximated and often off. These have
been adjusted from testing using the SPEEDRUN feature.
Kenny Levinsen